Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateStyles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
See the difference
Before
After
Before
After
Before
AfterHow Much Does Gate Installation Cost in Arleta?
Gate installation in Arleta typically runs $2,400 to $9,500 for most residential projects, depending on the gate material, the width of the opening, and whether you’re adding an automatic operator. A basic single-panel swing gate with a manual latch usually lands at the low end. A wide dual-swing driveway gate with a LiftMaster or FAAC operator and safety sensors runs toward the top. Every price we quote is set per job in a free written estimate, so what you see on paper is what you pay.
We’re an electric gate specialist, which matters for installation. The operator, the control board, the wiring, and the gate panel itself have to work as one system. Nine brands, one specialist team: LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule. We know the differences because we install and repair all of them.
Key Takeaways
- Typical installed range in Arleta: $2,400 to $9,500, with the operator adding $700 to $2,400 depending on the brand.
- Automatic gate installation costs more than a manual gate but saves you the second trip when you decide to automate later.
- Self-closing and latching requirements vary by opening and by what the city asks for, so confirm permits with Arleta’s building department before work starts.
- Free written estimates by phone: (855) 473-3106. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Gate Installation Cost Breakdown (2026)
Below are the line items we see most often on a residential gate installation in Arleta. These are estimates for planning. Your written estimate sets the final price after we look at the opening, the posts, and the power situation.
| Line item | Typical estimated range |
|---|---|
| Basic swing gate, single panel, manual | $1,200 – $3,200 |
| Dual swing gate, driveway width, manual | $2,800 – $6,500 |
| Sliding gate, residential | $2,500 – $6,000 |
| Automatic operator, residential grade (Mighty Mule, Ghost Controls) | $700 – $1,600 |
| Automatic operator, heavier duty (LiftMaster, Linear, Viking, Elite) | $1,200 – $2,400 |
| Commercial-grade operator (FAAC, BFT, DoorKing) | $1,800 – $4,500 |
| Safety sensors and reversing edges | $150 – $500 |
| Electrical run to the gate operator | $400 – $1,800 |
| Entry keypad, remote controls, and access control | $200 – $900 |
| Permit-related inspection and compliance work | $100 – $600 |
What pushes a job to the higher end? Wide openings, heavy materials, a long power run to the operator, and commercial duty cycles. What keeps it lower? A standard driveway width, a manual gate, and an existing conduit or outlet near the gate line. If you’re weighing an automatic system, call (855) 473-3106. We answer 24/7, and we’ll walk you through what each brand costs before you commit.
What Affects Gate Installation Pricing in Arleta
Two gates can measure the same and price very differently. Here’s what drives the number in this market.
- Gate material and weight. Wood, ornamental metal, and chain-link each behave differently with an operator. Heavier panels need a heavier operator, and the operator brand and class determine a big chunk of the total.
- Opening width and layout. A narrow pedestrian gate is a simple job. A driveway-width dual swing or a sliding gate needs more hardware, stronger posts, and more labor. The posts have to go to proper footing depth, which is where a lot of poorly installed gates fail.
- Operator brand and duty cycle. A lightweight residential opener like Mighty Mule or Ghost Controls is priced well below a commercial-grade FAAC, BFT, or DoorKing operator. If a property has frequent traffic, the heavier operator earns back the difference in service life. We work across the full range, so we match the operator to how the gate will actually be used.
- Power and wiring. If there’s no power at the gate line, running conduit and wiring adds to the cost. This varies a lot from property to property in Arleta.
- Access control and safety devices. Keypads, intercoms, remote controls, and reversing safety edges are line items. On an automated gate, safety devices aren’t optional extras. They protect people and pets.
- Permits and inspections. Most cities require a permit for a gate installation that involves electrical work, so ask Arleta’s building department what applies to your project before work starts. Permit and inspection fees vary.
Repair vs. Replace: Which Makes Sense?
If an existing automated gate has a failed operator or control board, a repair is often cheaper than a full replacement. We diagnose the specific system before recommending anything, because a motor that tests bad and a motor that’s actually fine need very different answers. For issues that come up after a gate is already in service, our gate repair Arleta specialists can take a look, and our team in Arleta handles both new installs and long-term repairs so you’re not tracking down a second vendor when something needs attention. A new installation usually costs more up front than a repair, but when the operator, hardware, and panel are all near the end of their life, replacing the system can be the better spend.
How to Save on Gate Installation
You don’t have to overpay, but cutting the wrong corner costs more down the road. A few practical moves:
- Get the estimate in writing. A free, itemized estimate shows you the gate, the operator, the wiring, and the access control as separate lines. You’ll see where the money goes and where you can pull back.
- Match the operator to real use. A lightweight residential opener is fine for a low-traffic home gate. A busy property needs the heavier duty cycle. Buying the wrong one means a replacement in a fraction of the time.
- Automate during installation, not after. Adding an operator at the time of installation costs less than retrofitting it later, because the wiring and mounting are done once.
- Plan the power run early. If the gate line needs a new electrical run, talk about it in the estimate rather than discovering it mid-install.
- Confirm permit requirements with the city before work starts, so there are no surprises on the inspection side.
Call (855) 473-3106 for a free estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Same-Day Service and Scheduling
For new installations, we schedule a site visit and then the install. For an existing gate that’s stopped working, same-day service is often possible. When you call, we ask what brand you have. If it’s one of the nine we work on, we know what we’re walking into. From installation to long-term repair, you’re working with the same team the whole way through. Call (855) 473-3106. We answer 24/7. A call outside dispatch hours is booked into the next opening, Sunday through Friday, 7am to 7pm.
Why Brand Familiarity Keeps Your Cost Down
Gate repair and installation get expensive when a technician is learning your system on the job. We work on LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule, which covers most of what’s already installed on residential and commercial properties here. Brand-agnostic diagnosis means we troubleshoot based on the actual system in front of us instead of steering you toward one product line. That’s what “your system, diagnosed correctly the first time” means in practice: fewer return trips, fewer parts swapped by guesswork, and a clearer path to a working gate. Our gate repair Arleta team does the installs, the repairs, and the electric gate work, so nothing gets handed off.
FAQs – Gate Installation Cost
How much does gate installation cost in Arleta?
Most residential gate installations in Arleta land between $2,400 and $9,500, including the operator on an automated gate. A simple manual swing gate is at the low end and a wide dual-swing driveway gate with a commercial-grade operator is at the high end. Call (855) 473-3106 for a free, itemized estimate that sets your final price.
How much does an automatic gate operator add to the cost?
An automatic operator adds roughly $700 to $2,400 for residential grade and $1,800 to $4,500 for commercial grade, depending on the brand and duty cycle. Safety sensors and access control are separate line items. Call (855) 473-3106 and we’ll price the operator that fits your gate.
Is it cheaper to repair a gate or replace it?
Repairing a gate usually costs less than a full replacement, especially when the panel and hardware are in good shape and only the operator or control board has failed. Replacement starts to make more sense when the operator, wiring, and panel are all near the end of their service life. We diagnose the specific system before recommending either path. Call (855) 473-3106 for a free estimate.
How long does gate installation take?
A standard single residential gate installs in a day; a dual-driveway or sliding gate with an operator and wiring can take several days depending on the power run and inspection schedule. We give you a realistic timeline in the written estimate. Call (855) 473-3106 to schedule a site visit.
Can you come today?
Same-day service is often possible for an existing gate that needs repair or diagnosis. New installations are scheduled after a site visit. Call (855) 473-3106. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Get a Free Gate Installation Estimate
If you’re planning a gate and want a real number, not a range in a blog post, the fastest way to get it is a call. Tell us the opening, the material you’re considering, and whether you want an operator. If you already have a system on the property, tell us the brand and we’ll recognize it. Nine brands, one specialist team, from installation to long-term repair. Call (855) 473-3106 for a free estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Written by the team at Gate Repair Arleta, Owner at Gate Repair Arleta, serving Arleta since 2018.
Pricing reflects the Arleta market as of 2026. Gate Repair Arleta offers free estimates – call (855) 473-3106.
What Our Customers Say
"Control board fried after a lightning storm. He showed me the burn mark on it, quoted the board, and installed a surge protector on the line so it hopefully doesn't happen again."
- Hector Herrera"Gate works properly now and the price was fair. The one thing is that it took two visits, because the operator model we have is old and the part had to be ordered. They didn't charge for the second trip."
- Stephanie Gallagher"Fixed the immediate problem. He was honest that the operator is near end of life and I should budget for a replacement, which I appreciate even if it wasn't what I wanted to hear."
- Xavier Freeman