Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateStyles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
See the difference
Before
After
Before
After
Before
AfterHow Much Does Gate Access Control Cost in Arleta?
Gate access control in Arleta typically costs $650 to $2,800 for most residential systems, covering keypads, card readers, vehicle loop detectors, intercom entry and the wiring that ties them to your existing operator. A simple keypad swap or a single new reader sits near the low end; a full multi-point entry system on a sliding or swing gate with phone access runs toward the top. The written estimate sets the final price, and the estimate itself is free.
Gate Access Control Cost Breakdown (2026)
Access control is rarely one part. It’s a chain: the entry device, the wire, the controller, and the gate operator that physically moves the leaf. Here’s how the line items usually break down in Arleta.
| Line item | Typical 2026 range (Arleta) |
|---|---|
| Standalone keypad (wired or wireless) | $180 – $420 |
| Telephone entry intercom (residential) | $550 – $1,400 |
| Card reader or fob reader (single door/gate) | $400 – $1,100 |
| Vehicle loop detector + wiring | $350 – $850 |
| Control board / access controller replacement | $450 – $1,200 |
| Low-voltage wiring run (per zone) | $120 – $400 |
| Phone or app-based access module | $300 – $750 |
| Full access control system (residential) | $1,400 – $2,800 |
| Commercial multi-reader system | $2,800 – $7,500+ |
| Diagnostic and repair of existing access control | $180 – $500 |
What pushes the number up: multiple entry points, a gate that’s a long distance from the house or the electrical panel, commercial-grade operators like FAAC, BFT or DoorKing where readers and controllers interact with heavier logic, and any case where the existing wiring has failed and needs to be run fresh. What keeps it down: reusing a working operator, keeping the reader count low, and choosing a keypad or phone module over a full intercom when one is enough. We’ve handled systems from LiftMaster and Linear residential setups through DoorKing commercial access, and the labor story is different for each. Call to get an exact quote – estimates are free: (855) 473-3106. We answer 24/7.
What Affects Gate Access Control Pricing in Arleta
- The operator you already have. A Mighty Mule or Ghost Controls residential arm is straightforward to add a reader to. A heavy FAAC or DoorKing operator on a commercial slide gate carries more logic and takes more time to integrate cleanly.
- Distance from power and from the house. Arleta homes sit on generous lots, and a gate at the far edge of the property means a longer low-voltage wire run and sometimes a buried conduit. That wiring line item is where small jobs turn into bigger ones.
- Number of entry points. A pedestrian gate plus a vehicle gate plus a front door reader means three zones. Each zone has its own device, wiring, and programming.
- Gate type – swing vs. slide. Slides tend to need a reversing loop and travel more mechanical parts, adding a few hundred dollars to the access control side. Swing gates with a residential arm are simpler.
- Existing wiring condition. In older Arleta properties we frequently find buried wire that’s been nicked, sunbaked, or spliced by a previous attempt. Replacing it is worth the money; leaving it means the new reader won’t behave.
- Time of replacement. A walkthrough and written estimate the day before work starts costs you nothing and catches the wiring problems before anyone swings a wrench. That’s why we estimate on site instead of over the phone.
How to Save on Gate Access Control
Access control pricing is mostly about labor and wiring, not the boxes themselves. Here’s where the money actually gets saved.
- Repair before replace. Many “dead” readers are a failed power supply, a corroded wire splice, or a controller that needs a reset. We diagnose the actual fault rather than swapping the reader and hoping. A $180-$500 diagnostic often beats a $1,100 replacement.
- Keep the working operator. If your gate motor still runs clean, there’s no reason to replace it to add a keypad or phone module. Your system, diagnosed correctly the first time, is cheaper than a system you didn’t need.
- Pick the access method that fits the property. A residential driveway with one regular car doesn’t need a full intercom. A keypad or phone access module delivers the same control for half the cost.
- Bundle zones in one visit. Adding a reader to the vehicle gate is the moment to run wire for the pedestrian gate too. One visit, one wiring run, one estimate.
- Fix the wiring, not just the device. If we find a splice fault, replace it properly. A reader is only as good as the wire feeding it. This is the single most common reason a new reader fails again in 6 months.
The estimate is free and the price is set per job in writing. Call (855) 473-3106 to book an on-site estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
FAQs – Gate Access Control Cost
How much does a keypad cost for a driveway gate in Arleta?
A driveway gate keypad in Arleta typically runs $180 to $420 installed, or $350 to $700 if wiring needs to be run fresh from the operator to the post. Wireless keypads sit lower because they skip the wire run. Call (855) 473-3106 for an exact quote – estimates are free.
Is it cheaper to repair or replace my gate access control?
Repair is almost always cheaper. A diagnostic and repair typically lands between $180 and $500, versus $1,400 to $2,800 for a full new residential access control system. Replacement only makes sense when the controller board is genuinely dead or the wiring is beyond saving. We diagnose the actual fault and tell you which side of that line you’re on.
Can you integrate access control with the operator I already own?
Yes. We work with nine major brands, including LiftMaster, Linear, FAAC, BFT, Viking, Ghost Controls, DoorKing, Elite and Mighty Mule, so most operators already on your property can be brought into an access control setup without replacement. Send us the make and model when you book and we’ll come prepared. Call (855) 473-3106.
Can I control my Arleta gate from my phone?
Yes, phone-based access modules typically cost $300 to $750 installed and work with most modern operators. That includes scheduling, remote open/close, and event logs. If your gate operator predates smartphone modules, we can often add a phone relay at the controller. Get an on-site estimate by calling (855) 473-3106.
Can you come today?
Same-day service is often available in Arleta. Call (855) 473-3106 and we’ll tell you what we can do. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. A call outside dispatch hours is booked into the next opening.
Why Arleta Gate Owners Work With Us
Gate Repair Arleta is a gate specialist, not a general fence or garage-door company that treats gates as a side job. That matters most on access control, because the device doesn’t live in isolation. It lives inside a chain that includes your operator, your control board, your wiring, and the gate leaf itself. When the chain breaks, knowing which link failed first is the difference between a $200 repair and a $2,000 replacement.
We work on nine brands: LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite and Mighty Mule. That range runs from lightweight residential openers to heavy-duty commercial operators, and it means we can look at your system once and diagnose it correctly rather than swapping parts to see what sticks. Electric gate repair is a core competency here, not an add-on. The same team that installs a new gate also repairs and services it, so there’s no gap between the installer and the repair tech.
We’ve served Arleta since 2018, and the access control work we see most often involves wiring that’s failed, controllers that need reprogramming, and homeowners upgrading from a plain remote to a keypad or phone module. If that’s where you are, gate repair in Arleta and access control work start with the same phone call.
Schedule Your Free Access Control Estimate in Arleta
Prices the written estimate sets, not the table above. The estimate is free and it happens on site, where we can see the wiring, the operator, and the gate together. Send us the brand and model when you book and we’ll come prepared. Arleta property owners and managers can call (855) 473-3106. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. Same-day service is often available. Your system, diagnosed correctly the first time.
Pricing reflects the Arleta market as of 2026. Gate Repair Arleta offers free estimates – call (855) 473-3106.
What Our Customers Say
"Solar panel on our remote gate wasn't keeping the battery up through the winter. He repositioned it, replaced the battery, and explained the math on why the old placement was never going to work."
- Diego Flores"Hinge post had rotted at the base and the whole swing gate was sagging into the concrete. He rebuilt the post rather than talking us into a whole new gate, which two other companies had pushed for."
- Lisa Brooks"Reprogrammed every clicker in the HOA and set up the keypad codes. Patient with a very long list of residents."
- Eduardo Castillo